Reversed Servos
#1
Senior Member
Thread Starter
Join Date: Mar 2003
Location: San Antonio TX USA
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
Reversed Servos
Is it possible to order servos from the factory with reversed rotation direction? I realize the Hitec digitals are easily programmed to reverse but I prefer Futaba or JR servos. I am installing two elevator servos on a Y harness and I prefer not to use a reversing lead because of hassles with the trim pot etc.
jmw
jmw
#3
Senior Member
Thread Starter
Join Date: Mar 2003
Location: San Antonio TX USA
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
RE: Reversed Servos
Thanks for that info Rich, do you have a web address for them? Also, are they modifying them in house or is this something they special order from the factory?
Thanks,
John
Thanks,
John
#5
Senior Member
My Feedback: (194)
Join Date: Aug 2002
Location: Santa Ana, CA
Posts: 379
Likes: 0
Received 0 Likes
on
0 Posts
RE: Reversed Servos
All servos can not be reversed by simply swapping wires - a lot of the modern servos have the motor and sometimes the pot soldered directly to the printed circuit board without any wires.
Also, if you don't own a small wattage soldering iron and are expereienced using it, it is not a good idea to go into something as crowded as a servo.
If yours can be reversed a service center can do it for you - or tell you if they are not so.
Also, if you don't own a small wattage soldering iron and are expereienced using it, it is not a good idea to go into something as crowded as a servo.
If yours can be reversed a service center can do it for you - or tell you if they are not so.
#7
Senior Member
Thread Starter
Join Date: Mar 2003
Location: San Antonio TX USA
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
RE: Reversed Servos
Are you suggesting one Futaba and one JR to drive the elevator halves? I suppose it could be made to work if the specs on the two servos were similar. Has anybody else tried this interesting solution to the split elevator problem?
jmw[8D]
jmw[8D]
#9
Senior Member
My Feedback: (5)
Join Date: Dec 2001
Location: Dun Rovin Ranch,
WY
Posts: 773
Likes: 0
Received 0 Likes
on
0 Posts
RE: Reversed Servos
John, sorry this is late, been away for the weekend. Don's website is www.donshobbyshop.com. The JR's I get from him are factory reversed.
Rich
Rich