HITEC HS77's ------ ANY GOOD ??
#1
Senior Member
Thread Starter
My Feedback: (5)
Join Date: Mar 2004
Location: Halifax,
NS, CANADA
Posts: 1,848
Likes: 0
Received 0 Likes
on
0 Posts
HITEC HS77's ------ ANY GOOD ??
I need 4 low profile servos for the ailerons on a 1.60 powered bipe. These servos LOOK perfect for the job but I have had other Hitec servos that were less than satisfactory. Any comments on the HS77 servos ? The alternatives ( JR or Futaba ) are 3 times the cost, but if I must, I guess I must.
Thanks ....................
Thanks ....................
#3
Senior Member
My Feedback: (45)
RE: HITEC HS77's ------ ANY GOOD ??
I have a set in my wings of 40 size profile plane with 100 runs with no problems I bought some used on E-bay one had a bad motor and after sending it back to Hitec they replaced it for free with a new one. I probably saved my plane at least 10 times with the fast roll over rate they are pretty fast. Give them a try just try and draw the line with 40 size planes you put them in. Some of the 60 and up size 3-D planes Have large surfaces to move and keep the motor working hard failure could result. SL
#4
Senior Member
Join Date: Sep 2003
Location: FishBlahhhhhhhh, HEARD ISLAND
Posts: 440
Likes: 0
Received 0 Likes
on
0 Posts
RE: HITEC HS77's ------ ANY GOOD ??
I use Hitec in most of my 1/4 scale planes and never had a problem. I'm using 2 HS 77BB's on the tail for elevator control of a 1/4 Scale Edge 540 and I'm using a HS 77 BB on the rudder of my Velox Rev II. I have tons of command over these surfaces.
I'm using HS 605's on the wings for ailerons and I also have a HS 645 MB on the rudder of the Edge 540.
Lots of confidence in Hitec here. The decision is entirely up to you though....after all, it's your plane.
I'm using HS 605's on the wings for ailerons and I also have a HS 645 MB on the rudder of the Edge 540.
Lots of confidence in Hitec here. The decision is entirely up to you though....after all, it's your plane.