View your mixers thru the PC audio input
10-25-2004, 12:11 PM
#1
Senior Member
Thread Starter
Join Date: May 2004
Location: Brussels, BELGIUM
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
View your mixers thru the PC audio input
An 'audio' interface is now available on one of the (simple)PCM softwares.
The analyser shows all channels of your transmitter in real time, and the servo link
with exact geometry and forces, on a graphic display.
You connect your transmitter PPM signal (buddy box connector) by a simple shielded cable
to the MIC audio input of your PC.
No other components needed, no drivers, no system changes.
The resolution will be reduced compared to the connection by a PIC cable, but you
can easily observe your mixers with this simple connection.
Download: http://www.jdm-nivelles.be/fichiers/fms/Analyser31.exe
It is a beta-version.
The glider and helico softwares will follow soon with this additional interface.
Link to all doocs and downloads: http://www.jdm-nivelles.be/fichiers/fms/SPCMliste.htm
Philippe
Brussels Belgium
The analyser shows all channels of your transmitter in real time, and the servo link
with exact geometry and forces, on a graphic display.
You connect your transmitter PPM signal (buddy box connector) by a simple shielded cable
to the MIC audio input of your PC.
No other components needed, no drivers, no system changes.
The resolution will be reduced compared to the connection by a PIC cable, but you
can easily observe your mixers with this simple connection.
Download: http://www.jdm-nivelles.be/fichiers/fms/Analyser31.exe
It is a beta-version.
The glider and helico softwares will follow soon with this additional interface.
Link to all doocs and downloads: http://www.jdm-nivelles.be/fichiers/fms/SPCMliste.htm
Philippe
Brussels Belgium
12-12-2004, 12:13 PM
#2
Senior Member
Thread Starter
Join Date: May 2004
Location: Brussels, BELGIUM
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
RE: View your mixers thru the PC audio input
This soft also includes the graphical display of the servo to control surface linkage, where you can modify all geometry and torque parameters.
