RC Radios, Transmitters, Receivers, Servos, gyros Discussion all about rc radios, transmitters, receivers, servos, etc.

Antenna Wire - Cut & Solder

Reply

Old 02-06-2005, 04:47 PM
  #1  
Pavan
Member
Thread Starter
 
Join Date: May 2004
Location: LeonGuajanuato, MEXICO
Posts: 47
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default Antenna Wire - Cut & Solder

I had a very bad nick on my receiver antenna wire. It was barely hanging on by a few strands of wire. Luckily I cought it in time. However I did not face and reduced range strange behaviour.

I just cut the wire where it was damaged. Soldered it back and put heat shrink tube on top.

I lost about 3 inch total length of the antenna wire.

Question: Is it safe for me to use this receiver? Any steps I should follow before launching a bird in the air?
Pavan is offline  
Reply With Quote
Old 02-06-2005, 05:01 PM
  #2  
Rodney
Senior Member
 
Join Date: Dec 2001
Location: FL
Posts: 7,769
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Antenna Wire - Cut & Solder

Yes, as long as you made a good solder joint. It would not hurt to add a few inches onto the end, just solder on enough to make the total length anywhere from 39 to 41 inches long.
Rodney is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service