Servo Tester
#1
Thread Starter
Join Date: Jul 2005
Location: Barra da Tijuca Rio de Janeiro, BRAZIL
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Servo Tester
Hi you !
I need help to homebuild a servo tester to check some unlabeled second hand multiplex. Thanks for any help.
IGOS R/C
#5
Thread Starter
Join Date: Jul 2005
Location: Barra da Tijuca Rio de Janeiro, BRAZIL
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Tester
Hi JNorton and Mglavin !!
Thank you very much for your hints. I will fit the servos which I intend to check on a 1/8" ply, use a 1" arm, use fishing pre weighted, hang up everything and run the test. That's all.
Thanks again.
IGOS R/C
#8
My Feedback: (5)
Join Date: Jan 2002
Location: San Tan Valley,
AZ
Posts: 5,768
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Tester
Instead of an arm use a 1"wheel attached to the top of an arm. Then you don't have to correct for the geometry of the arm. Also a dial indicator is much better than a pointer. Just attach it to the wheel with a string. A cheap dial indicator is accurate to .001 in.
#9
Thread Starter
Join Date: Jul 2005
Location: Barra da Tijuca Rio de Janeiro, BRAZIL
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Tester
Hi !
Thanks for your input Dirtybirdi.
IGOS R/C
__________________________________________________ ____________________
Even my shelf queen beauty suffered a crash due to a screw failure. All planes crash.