RC Radios, Transmitters, Receivers, Servos, gyros Discussion all about rc radios, transmitters, receivers, servos, etc.

Futaba 9Z questions

Reply

Old 08-15-2005, 08:00 PM
  #1  
pilott34
Senior Member
Thread Starter
 
Join Date: Dec 2004
Location: milton, FL
Posts: 375
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default Futaba 9Z questions

Hello,

I just have 2 questions regarding my 9Z. I looked on futabas FAQ page and couldnt find anything.


(1) I need to program the radio so that when I put the landing gear down, I get 6 clicks of down elevator with it. Anyone know how to do this??

(2) I have 2 JR 3301 servos, one for each elevator. If I plug them into 2 separate channels, they match up at the top of movement and at the centerpoint. However, in between one servo moves faster than the other then it catches up right before full travel. I put them on a Y harness and they work great. Anyone know what the prob is??

Thanks,
Mike
pilott34 is offline  
Reply With Quote
Old 08-17-2005, 05:16 PM
  #2  
JohnW
Senior Member
My Feedback: (6)
 
JohnW's Avatar
 
Join Date: Mar 2002
Location: Lincoln, NE
Posts: 1,815
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Futaba 9Z questions

1) Two ways to kill that bird I can think of off the top of my head. You can use an offset mix slaved to the same switch you use for gear. OR, you can set up a landing condition where the trim is preset where you want.

2) Check your setup mixes etc closely. Are you using a PMX to drive the servo's or are you using the Ailevator mix?
JohnW is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service