Hitec radio and throttle cut problem
#1
Junior Member
Thread Starter
Join Date: Jan 2005
Location: Port Orchard, WA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hitec radio and throttle cut problem
Hello,
I am having problems reversing the throttle cut movement. I can adjust the +/- %, but am unable to reverse the direction when the throttle cut button is pushed. Anyone know how to reverse the throttle cut movement on a Hitec radio? Thanks.
Talon29
I am having problems reversing the throttle cut movement. I can adjust the +/- %, but am unable to reverse the direction when the throttle cut button is pushed. Anyone know how to reverse the throttle cut movement on a Hitec radio? Thanks.
Talon29
#2
Senior Member
Join Date: May 2003
Location: Danville,
CA
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
RE: Hitec radio and throttle cut problem
When you press throttle cut, the throttle servo goes to the position you have set for throttle cut. Since the main stick will move you from 0 to 100%, a throttle cut setting of -20% should move the throttle servo to 20% lower than minimum throttle. Why would you want to reverse this? You do have to be sure that your engine carburetor will allow you to do this, and you should mechanically adjust the throttle linkage so that at minimum throttle, the engine is still running, but not at the throttle stop (if any) on the carb.