Glitching range check/metallic covering????
#1
Thread Starter
My Feedback: (10)
Join Date: Aug 2002
Location: winter springs,
FL,
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Glitching range check/metallic covering????
This is a confusing issue. With the antenna wire inside or next to my Hobbico Extra ARF fuslage, a 60 to 75' range check shows servo gitching, but yet rudder control visble at 100'.
Is this glitching a problem. It did not appear to be on the maiden flight and was only noticed while picking the plane up on the runway afterwards.
I changed the receiver and transmitter and found the same results. I also changed servo's, one at a time to see if one may be faulty. All to no avail.
Customer Service had not heard of the metallic covering/interference issue but did offer new Monokote covering material.
Any similar experiences out there with successful remedies???
Is this glitching a problem. It did not appear to be on the maiden flight and was only noticed while picking the plane up on the runway afterwards.
I changed the receiver and transmitter and found the same results. I also changed servo's, one at a time to see if one may be faulty. All to no avail.
Customer Service had not heard of the metallic covering/interference issue but did offer new Monokote covering material.
Any similar experiences out there with successful remedies???