microengine

I need the experts advice here. I will be running a very light model which should be under 10oz ready to run, called starlite / starlight, with 35" span with a tiny pb 033 diesel. I need some seriously light kit: 3 servos and a receiver etc. I want a minimum of 4ch for TX & RX, so I can progress from 3 to 4ch later on.


So what's the best / lightest / most reliable well made gear, with cost not being much of an issue?







P.S for use with:

http://www.peterburford.com.au/

http://www.rcuniverse.com/product_gu...fm?kit_id=1126

microengine

bump

simark

My Feedback: (12)

Try the Berg 4L Microstamp 4X DC full range receiver.
I just received one and I can't believe how small it is.
I don't know which servos will work for you but there a quite a few micro servos out there.

microengine

That's amazingly small and cheap. Can it really be reliable?

simark

My Feedback: (12)

I don't know how reliable, but Berg products have always had good comments here on RCU.
Here is where I purchased mine.
http://www.zebrahobby.ca
Check with them about shipping to the UK.