Futaba 9CAP HELP
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Auckland, NEW ZEALAND
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 9CAP HELP
Hi
I have 2 questions.
1. If i want to copy one model from a 9 CAP to another 9CAP using the connection cable that goes into the back of the transmitter how do i go about this?
2. Could someone give me the step by step procedure in Mixing in a Bit of Rudder with Ailerons??
Ray
I have 2 questions.
1. If i want to copy one model from a 9 CAP to another 9CAP using the connection cable that goes into the back of the transmitter how do i go about this?
2. Could someone give me the step by step procedure in Mixing in a Bit of Rudder with Ailerons??
Ray
#2
Senior Member
Join Date: Apr 2005
Location: Frampton-on-Severn, UNITED KINGDOM
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 9CAP HELP
!. I've not heard of it being done by cable. You can do it by using a Campac, copying it from the Campac to a Tx memory on the second Tx
2. Use a Pmix.
Master is aileron
Slave is rudder
link on
trim off
switch you can assign it to any switch so you can turn it off and on if required
2. Use a Pmix.
Master is aileron
Slave is rudder
link on
trim off
switch you can assign it to any switch so you can turn it off and on if required