JSGJSialop

I'm thinking about changing the DX6 over to a 3c lipo. My concern is that the transmitter is still going to think that the battery is running low at 9.8v which is not even close for a 3c lipo. This would mean that you really aren't getting the full run time you would expect for this swap. Anyone done the conversion and experience this?

Thanks

Mac_Man_UK

Why would the Tx think its low at 9.8 V ?? JR radios alarm at 9.0V unless it has been changed during a calibration.

JSGJSialop

Your right, my dyslexia was kicking in. It's 8.9 volts but that's still above the actually empty voltage for the 3c lipo.