BEC w/jeti 110 and airtronics mini reciever
#1
Senior Member
Thread Starter
Join Date: Feb 2003
Location: Middletown,
IN
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
BEC w/jeti 110 and airtronics mini reciever
I have a jeti 110 motor controller and an Airtronics 91515z mini reciever. I understand how the reciever gets power w/o BEC, but jeti recommends using BEC. So how does the reciever get power if I do not use the Nicd pack? Also, there was no diagram telling me what all 5 slots in the reciever are. The first 2 had the mini servos plugged in from the factory. The fifth one says 5/B. Isnt that where the power from the nicad pack plugs in? If I plug the motor controller in the 3rd slot will that power the reciever?
#2
Senior Member
Join Date: Mar 2002
Location: Reading, UNITED KINGDOM
Posts: 904
Likes: 0
Received 0 Likes
on
0 Posts
BEC w/jeti 110 and airtronics mini reciever
It is possible to apply the power to any of the receiver slots, the power connections are all linked together. So the ESC is plugged into the normal throttle channel.
Steve
Steve