futaba servo specs needed. please read
#1
Thread Starter
My Feedback: (6)
Join Date: Jul 2005
Location: clinton twp,
MI
Posts: 207
Likes: 0
Received 0 Likes
on
0 Posts
futaba servo specs needed. please read
hey guys, I am looking for the specs on the following two servos:
1) Futaba S9301
2) Futaba S9304
Also, can these be safely used with a 5 cell sub-c nicad 2400 mah pack?
thanks in advance
larry
1) Futaba S9301
2) Futaba S9304
Also, can these be safely used with a 5 cell sub-c nicad 2400 mah pack?
thanks in advance
larry
#3
Junior Member
Join Date: Nov 2005
Location: Eva,
AL
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
RE: futaba servo specs needed. please read
From the Futaba Site.
Both the S9301 and the S9304 are discontinued and are analog.
Both are replaced by the S9202
Torque 69.5 oz.in.
Dim (LxWxH) inches 1.59 x 0.79 x 1.40
Connector type=J
Weight 1.7 oz.
Speed 60 degrees in 0.22 seconds
I hope this helps.
Stevel
Both the S9301 and the S9304 are discontinued and are analog.
Both are replaced by the S9202
Torque 69.5 oz.in.
Dim (LxWxH) inches 1.59 x 0.79 x 1.40
Connector type=J
Weight 1.7 oz.
Speed 60 degrees in 0.22 seconds
I hope this helps.
Stevel