crossed wire's on hitec receiver
#1
Senior Member
Thread Starter
Join Date: Oct 2002
Location: gurdon,
AR
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
crossed wire's on hitec receiver
i changed the pin's on an airtronics servo lead to use with a hitec 555 receiver. had a brain cramp and crossed my wires,now i have a burnt servo and no channel 4 on the receiver anymore. can the receiver be repaired, Thank's FOD MAN
#3
Senior Member
Join Date: Sep 2002
Location: Rochester,
NY
Posts: 1,373
Likes: 0
Received 0 Likes
on
0 Posts
crossed wire's on hitec receiver
You probably fried something in the decoder chip.. The whole chip would have to be replaced, I doubt that'd be cheaper than buying a new receiver.. P.S. Don't feel too bad I've done this myself, I tossed the receiver then again it was a cheap old AM reciever.
#4
Senior Member
Thread Starter
Join Date: Oct 2002
Location: gurdon,
AR
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
crossed wire's on hitec receiver
I can still use it in a h.o.b bonanza and a .10 shrike that i have as they only need the first 3 channels . so maybe not all is lost. thanks fod man