reynolds74

Hi everybody,

I'd need to know whether the 5955TG will take some play after sometime, as it seems happening to other metal gear servos, or if it's ture they're (almost) bullet proof under this point of view.
I'm planning to use them on 80inches 3D airplanes, with 50cc gasoline engines.
I'm not concerned about the price if I can get the ultimate servo!

Regards,

Andrea

exeter_acres

My Feedback: (2)

http://www.rcuniverse.com/forum/m_58...tm.htm#5885610

martin salgado

Hello Andrea,

We have not seen any wear in the 5955 servos since the time they have been released.

gadix

My Feedback: (2)

andrea como va?

the 5955 will take a 42% models with 150cc, so your 50cc is more than ok

if u use it for rudder than no problem, all other surfaces need smaller servos like the 5645

ciao

gadi