Hobbico Rx.
03-31-2003, 06:26 AM
#1
Member
Thread Starter
Join Date: Mar 2002
Location: Kathleen,
GA
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Hobbico Rx.
I Have a hobbico command receiver can any one tell me, being it uses Futaba crystals, If this receiver is a high or low band receiver like Futaba or can you plug any crystal in and have it work properly. I have emailed hobbico tech help and they will not respond with an answer.
Thanks Fred
Thanks Fred
03-31-2003, 04:28 PM
#2
My Feedback: (11)
Hobbico Rx.
Unless the receiver's marked, you can't tell just by looking at it whether it's hi or lo band. If you put in a crystal and get a good range check, you'll be OK. Otherwise, you'll need to get the receiver retuned.
Please be advised that all emails sent to us are answered, usually within 48 hours or so. With the large amount of emails received, an answer within a few hours, or even the same day is not always possible.
Please be advised that all emails sent to us are answered, usually within 48 hours or so. With the large amount of emails received, an answer within a few hours, or even the same day is not always possible.
