Futaba Servo Horn Drawings
01-16-2008, 08:37 AM
#1
Junior Member
Thread Starter
Join Date: Jan 2008
Location: , AUSTRALIA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Futaba Servo Horn Drawings
Hello,
i am trying to make a part to fit onto the spline of a futaba servo. does anyone know where i could get the drawing details of futaba's splines?
any nudges in the right direction would be greatly appreciated!
thanks
i am trying to make a part to fit onto the spline of a futaba servo. does anyone know where i could get the drawing details of futaba's splines?
any nudges in the right direction would be greatly appreciated!
thanks
