RC Radios, Transmitters, Receivers, Servos, gyros Discussion all about rc radios, transmitters, receivers, servos, etc.

resistance of a standard JR/Hitec/Fut connector

Reply

Old 02-09-2008, 04:46 PM
  #1  
les40
Senior Member
Thread Starter
My Feedback: (1)
 
Join Date: Sep 2003
Location: Tucson, AZ
Posts: 423
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default resistance of a standard JR/Hitec/Fut connector

Does anyone know what the approximate resistance of the standard servo/rx connectors?
les40 is offline  
Reply With Quote
Old 02-09-2008, 06:26 PM
  #2  
Julez
Senior Member
 
Join Date: Jan 2007
Location: , GERMANY
Posts: 184
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: resistance of a standard JR/Hitec/Fut connector

In the neighborhood of 5mOhm
Julez is offline  
Reply With Quote
Old 02-09-2008, 08:12 PM
  #3  
bruce88123
 
Join Date: Nov 2004
Location: Memphis, TN
Posts: 11,703
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: resistance of a standard JR/Hitec/Fut connector


ORIGINAL: Julez

In the neighborhood of 5mOhm
For those not familiar with mOhm that equals 0.005 ohms which means = don't worry about it. This assumes good clean contacts and preferably gold plated.
bruce88123 is offline  
Reply With Quote
Old 02-10-2008, 10:00 AM
  #4  
Rodney
Senior Member
 
Join Date: Dec 2001
Location: FL
Posts: 7,769
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: resistance of a standard JR/Hitec/Fut connector

Unfortunately, a cheap connector (not gold plated) and a little dirt, corrosion and oil can push this up to well over an ohm and is often a problem with extensions that do not get periodically cycled (unplugged and plugged). How many times have you seen aileron servos jitter a bit until the connectors were cycled a few times?
Rodney is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service