RC Radios, Transmitters, Receivers, Servos, gyros Discussion all about rc radios, transmitters, receivers, servos, etc.

JR X9303 r921 Bind Problems

Reply

Old 02-10-2008, 02:00 PM
  #1  
morrisonjmk2
Junior Member
Thread Starter
 
Join Date: Feb 2008
Location: Los Realejos, SPAIN
Posts: 6
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default JR X9303 r921 Bind Problems


Hello, I am from spain, I recently bought a transmitter to receiver JR R921 and I have trouble blind, "is just connects when it wants, if times turn 10 connects 1 or 2 times, they could help me? I have to return it to the seller or call JR? Thank you.

morrisonjmk2 is offline  
Reply With Quote
Old 02-10-2008, 05:15 PM
  #2  
morrisonjmk2
Junior Member
Thread Starter
 
Join Date: Feb 2008
Location: Los Realejos, SPAIN
Posts: 6
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

any help me? please
morrisonjmk2 is offline  
Reply With Quote
Old 02-10-2008, 05:34 PM
  #3  
Panzlflyer
Senior Member
My Feedback: (15)
 
Panzlflyer's Avatar
 
Join Date: Feb 2002
Location: Goldsboro, NC
Posts: 1,960
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

Take the bind plug and make sure its bound.
Check your voltage to the reciever most problems in setup are voltage or binding, ie after putting together a new plane and using a 4.8v pack that was lying around it would not bind due to low voltage, fresh pack fully charged no more problems
Panzlflyer is offline  
Reply With Quote
Old 02-10-2008, 05:48 PM
  #4  
damroadhog
 
Join Date: Oct 2006
Location: Rockford, IL
Posts: 140
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

Send it back or send it in to JR

Had the same problem, would not bind then it would but the servos went wild, turn it off and on and no servo movement at all , then it would bind , one elv up, one down at full deflection, rudder full right.
there are some bad units out there.

Never had this problem with any other Spectrum 2.4 set up.

Don't waste your time with it send it back!!!!! Do not trust the red 921 unit

Put the 9100 in the same plane , and no problems at all.


Dave
damroadhog is offline  
Reply With Quote
Old 02-10-2008, 05:52 PM
  #5  
fenway flyer
Junior Member
 
Join Date: May 2007
Location: smyrna, DE
Posts: 13
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

I've had truoble with the red 921 also. What a shame.
fenway flyer is offline  
Reply With Quote
Old 02-10-2008, 05:56 PM
  #6  
morrisonjmk2
Junior Member
Thread Starter
 
Join Date: Feb 2008
Location: Los Realejos, SPAIN
Posts: 6
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

He connected with the new cable station and the receiver and is doing the same thing, the battery is a new CN 2400 4.8 and charged flight once and then no longer connects more, I hope if 10 minutes or more if you connect but takes to connect. Thank you for responding
morrisonjmk2 is offline  
Reply With Quote
Old 02-10-2008, 06:01 PM
  #7  
morrisonjmk2
Junior Member
Thread Starter
 
Join Date: Feb 2008
Location: Los Realejos, SPAIN
Posts: 6
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems


then only the command receiver JR, and while I buy a AR9000 of spectrum?
morrisonjmk2 is offline  
Reply With Quote
Old 02-10-2008, 06:33 PM
  #8  
damroadhog
 
Join Date: Oct 2006
Location: Rockford, IL
Posts: 140
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

Re: 921


Keep your Radio, call JR or Horizon, tell them about your problem and send just the RX in. if you can ask for an exchange or credit , get the JR-922 or the Spectrum 9100, these are the best money can buy .....

Get the number off the back of the book that came with your radio and call them.


Dave
damroadhog is offline  
Reply With Quote
Old 02-10-2008, 06:44 PM
  #9  
morrisonjmk2
Junior Member
Thread Starter
 
Join Date: Feb 2008
Location: Los Realejos, SPAIN
Posts: 6
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: JR X9303 r921 Bind Problems

thanks thanks thanks
morrisonjmk2 is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service