I need a mix
#1
Thread Starter
My Feedback: (62)
Join Date: Dec 2001
Location: Vineland,
NJ
Posts: 3,856
Likes: 0
Received 0 Likes
on
0 Posts
I need a mix
What I'd like to do in essence is set up the equivalent of a dual rate for throttle.
I've tried to use a rotary knob as a total throw limiter with no success.
Is there a way to use a knob to adjust the total throw?
Radio is a 10X which may or may not matter.
I've tried THRO->Aux4, and THRO->THRO with no success.
I'd rather not use the curve if I don't have to.
Thanks
Bob
I've tried to use a rotary knob as a total throw limiter with no success.
Is there a way to use a knob to adjust the total throw?
Radio is a 10X which may or may not matter.
I've tried THRO->Aux4, and THRO->THRO with no success.
I'd rather not use the curve if I don't have to.
Thanks
Bob
#2
Senior Member
My Feedback: (31)
Join Date: Mar 2002
Location: Kannapolis,
NC
Posts: 7,415
Likes: 0
Received 0 Likes
on
0 Posts
RE: I need a mix
bob are you trying to limit the travel at times with the throttle or something else. i have put my throttle on a gear to throttle mix for high idle that is used for flying then when i am ready to land i bump that switch off and go back to a 1350 or so idle depending on the motor (this being gas motors) yes that same mix can be on a glow deal also. well its off to bed for me....
#4
Thread Starter
My Feedback: (62)
Join Date: Dec 2001
Location: Vineland,
NJ
Posts: 3,856
Likes: 0
Received 0 Likes
on
0 Posts
RE: I need a mix
It's a work related UAV issue.
I want to run/taxi the fuse at a fixed throttle setting, and at different speeds.
I'm thinking if I put the total throw/engine rpm on a dial, when I throttle up I'm not
guessing at what stick position I was on the last run to make the next one just a little faster.
krazy - I do the same thing with the slider on my 10X for in flight throttle trim, but this is a little different.
Thanks for the replies.
Bob
I want to run/taxi the fuse at a fixed throttle setting, and at different speeds.
I'm thinking if I put the total throw/engine rpm on a dial, when I throttle up I'm not
guessing at what stick position I was on the last run to make the next one just a little faster.
krazy - I do the same thing with the slider on my 10X for in flight throttle trim, but this is a little different.
Thanks for the replies.
Bob