Multiplex 4000? with Servos
#1
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Dec 2002
Location: Kelso,
WA
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Multiplex 4000? with Servos
Switched from JR to Futaba Servos. I can get 90 degrees travel on rudder. I only seem to be getting 45 on the other 6 servos. I have travels, limits and curves the same. Where am I going wrong?
#2
Join Date: Oct 2002
Location: Leeds, UNITED KINGDOM
Posts: 1,449
Likes: 0
Received 11 Likes
on
8 Posts
MC4000 servo Travel
I need more information! There are a number of ways in which you can limit servo travel. Have you checked in Menu 1, Controls? Here you can limit travel of each control, set rates, etc.
Then in Menu 1, Servos you can set travel end points, limits etc.
Are any mixers assigned?
regards,
John
Then in Menu 1, Servos you can set travel end points, limits etc.
Are any mixers assigned?
regards,
John