zx10 rx to brushless?
01-26-2009, 08:43 AM
#1
Member
Thread Starter
Join Date: Dec 2008
Location: Means, KY
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
zx10 rx to brushless?
Im thinking about getting a 5ch zx10 tx/rx as a budget deal for an easy star.
I may never convert the motor to brushless but out of curiosity, lets say I plan too...would the brushless motor plug directly to the ZX10 receiver or do I need a special board? Ive read two different responses to this and Im not sure which applies to me, one says, no, will work fine, another says I need a brush2less or EZ ESC circuit board.......then I read where RTF kits come with the ZX10 and brushless.
I think the TX/RX im looking at comes from a t-28 rtf kit if that matters.
thanks
I may never convert the motor to brushless but out of curiosity, lets say I plan too...would the brushless motor plug directly to the ZX10 receiver or do I need a special board? Ive read two different responses to this and Im not sure which applies to me, one says, no, will work fine, another says I need a brush2less or EZ ESC circuit board.......then I read where RTF kits come with the ZX10 and brushless.
I think the TX/RX im looking at comes from a t-28 rtf kit if that matters.
thanks
