Top_Gunn

My Feedback: (6)

I put two new Hitec HS-82MG servos in a new plane (Futaba 2.4 GH radio). Both of them buzz, even when they aren't attached to anything. They buzz whenever I move the sticks, and sometimes at neutral, too, though if I flick the stick at neutral, the buzzing stops. Any suggestions?

I posted this under Hitec support, but got no reply, so I thought I'd try here.

dirtybird

My Feedback: (5)

What battery and voltage are you using?

Top_Gunn

My Feedback: (6)

4.8 volt 4-cell Sanyo NiCad pack.

Top_Gunn

My Feedback: (6)

Hitec tech support came through. Loosened the four screws holding the case on a quarter-turn, and the buzzing stopped.