Help programing JR 8103
#1
Thread Starter
My Feedback: (11)
Join Date: Mar 2002
Location: Aurora,
CO
Posts: 441
Likes: 0
Received 0 Likes
on
0 Posts
Help programing JR 8103
I need a little help with my set up...here's what I have:
JR8103
8 channel receiver
1 servo per aileron
1 servo for flaps
I would like the Elev/land switch in the far position to set take off flaps, middle position no flaps and in the close position to set landing flaps. Is this possible, or is there a better way? One note, I'd like to have each aileron servo operated from a different channel.
JR8103
8 channel receiver
1 servo per aileron
1 servo for flaps
I would like the Elev/land switch in the far position to set take off flaps, middle position no flaps and in the close position to set landing flaps. Is this possible, or is there a better way? One note, I'd like to have each aileron servo operated from a different channel.
#2
Junior Member
Join Date: Jun 2003
Location: San Jose
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Help programing JR 8103
I would call Horizon Product Support, they are good about setup issues like that. Even ask to talk to a man by the name of Dennis Davenport, he is an expert on 8103 setups.