10x program issue
#1
Thread Starter
My Feedback: (60)
10x program issue
Guys, we just finished wiring everything up and went to start programming and the only channel for the mini hobby brake valve is aux 4. Please don't suggest another channel, we used every of all 10 channels up and becuase of the refresh rate, steering had to go on aux five and brakes on aux 4.
So, I went to my 10 and turned off the aux 4 knob which would be impossible to use anyway.
I made a mix of aux 4 to aux 4 and made it changeable by the snap roll button.
Tried 5 differenct ways of changing units etc, hold button this that and the other and can't get it to work.
If anyone has a setup on the bench that they can get this to work, please post me some instructions. We are dead in the water on this issue.
Thanks in advance.
So, I went to my 10 and turned off the aux 4 knob which would be impossible to use anyway.
I made a mix of aux 4 to aux 4 and made it changeable by the snap roll button.
Tried 5 differenct ways of changing units etc, hold button this that and the other and can't get it to work.
If anyone has a setup on the bench that they can get this to work, please post me some instructions. We are dead in the water on this issue.
Thanks in advance.