Receiver question
07-23-2003, 12:40 PM
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Jan 2002
Location: barnsdall, OK
Posts: 218
Likes: 0
Received 0 Likes
on
0 Posts
Receiver question
I have a seven channel rx and am needing another channel to run a smoke system. Seems like I had read that it was possible to y harness into the batt port and use a servo this way. Well I tried it with my 9cap and it works but the servo will only respond with the rudder control. Any way to assign this servo to a switch?
