How to program split elevator servos on JR 8103?
 

Lost my instructions on how to do this without servo reversing. I remember one goes to aux 3 and the other to elevator on the reciever, but I can not remember the rest.
Thanks for the help.

RE: How to program split elevator servos on JR 8103?
 

I believe you need to use one of the mixes, and slave the aux channel to the elevator channel, at 100%. At least, that is what I do on my 8103.

RE: How to program split elevator servos on JR 8103?
 

You can download the manual at www.horizonhobby.com

This might help:
http://horizon.hobbyshopnow.com/shar...amming-air.pdf

Or this is the entire manual in PDF. It's 2+ MB
http://horizon.hobbyshopnow.com/shar...612-manual.pdf

Hope this helps out.

RE: How to program split elevator servos on JR 8103?
 

thanks rcpilet,

I wasnt sure which radio to buy, I was leaning towards the JR 8103. But now that I've read the manual, I'm definitely getting the 8103. The manual actually cleared up alot of questions and have about radio's in general.

RE: How to program split elevator servos on JR 8103?
 

The 8103 has 6 mixes of 3 different types, in addition to the usual elev-flap and ail-rud. This is on the acro program, I can't speak for helis & gliders.

2 mixes are multi-point mixes
2 are standard mixes without trim
2 mixes include trim. I use one of these for dual elevator channels. The trim moves both channels. The include trim mixes are also good for V-tail if you don't want to use the glider program.

Very nice radio.