Jeti REX10 Assist new firmware problem
Hi all!
I'm having a problem with my REX 10 assist receiver just after the update to firmware 1.12 from 1.09: switching on the receiver I have a message on transmitter saying "Hold Leveled" and the receiver doesn't run. Naturally the model is steady still on a table, no any vibration or movement. With firmware 1.10 problem is the same. Back to older firmware 1.09 everything works fine. Anyone experienced any similar problem? Thank you very much for your help |
Originally Posted by raddrilene
(Post 12548729)
Hi all!
I'm having a problem with my REX 10 assist receiver just after the update to firmware 1.12 from 1.09: switching on the receiver I have a message on transmitter saying "Hold Leveled" and the receiver doesn't run. Naturally the model is steady still on a table, no any vibration or movement. With firmware 1.10 problem is the same. Back to older firmware 1.09 everything works fine. Anyone experienced any similar problem? Thank you very much for your help |
All times are GMT -8. The time now is 10:29 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.