2 for 1
I am building a Midwest Hots II. It calls for 1 standard servo to run both ailerons. I decided to run 2 servos. I'm ready to mount them but have a question!
Can I replace one standard servo with two Hitec m81's ? They are suposed to have 36oz/torque compared to the standard deluxe at 43oz, which I think would be fine, but will the gears hold up? |
RE: 2 for 1
They might... However, I would think that metal gears would be better for this application... The HS-85MG is a great little servo for these kinds of installations. I used them on the elevator halves and rudder of a 40 sized CAP with great success.
|
RE: 2 for 1
i've been through tons of hot's in my time, all one piece with clipped wings and piped YS .45s.
first one had a single standard servo, no lack of torque but serious flutter problems. all my hots after that got a pair of standards or airtronics 401 minis and both worked fine. also be sure to seal your hinge gaps. i cover the wings and ailerons after hinging dave |
All times are GMT -8. The time now is 08:27 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.