AE .15 help
#1
Senior Member
Thread Starter
My Feedback: (2)
Join Date: Jun 2005
Location: Phoenix,
AZ
Posts: 1,589
Likes: 0
Received 0 Likes
on
0 Posts
AE .15 help
I just can't figure it out. My Nitro TC3 plus had started to act wierd.
About a week ago, I was doing some full throttle passes and the engine started heavily boging. The symptons to me were of overheating do to lean set needle valve. I drove up to my little pit stop and richened her up. Poblemed solve, but than just five minutes later, it did it again. Every time I richen it the problem stops for about 5 minutes. Low end adjustment might be the problem but it seems to be right on IMO.
Any Ideas?
About a week ago, I was doing some full throttle passes and the engine started heavily boging. The symptons to me were of overheating do to lean set needle valve. I drove up to my little pit stop and richened her up. Poblemed solve, but than just five minutes later, it did it again. Every time I richen it the problem stops for about 5 minutes. Low end adjustment might be the problem but it seems to be right on IMO.
Any Ideas?