Mike Flea

2 thumbs up! good to go!

RustedRC

Got it together and will be bolting it in tomorrow.
i'm off this week end and hoping to get out to play. ill try to get some pic's with my old crappy phone.

RustedRC

I bet it's nice and warm down in AZ. here in PA it's like 8 months winter and 2 months spring and 2 months fall. feels like if i blink i miss summer all together.
thanks for the invite ZackS30. maybe one day i can get down there for a vaca. with my honcho of course.
ok so if i mirror the tranny then the spur cover won't fit right?

RustedRC

So a few more parts showed up today. got to trim the spur cover and get them on.

phmaximus

Have u thought about mirroring the trans?? It's a good little trick to reduce torque twist

zackS30

For sure that invite is always open to u and my FAM here. I'm always looking for someone to go out with. My wraith is down ATM. :/ damn spektrum servo stripped.

RustedRC

Yeah phmaximus i thought about it but then i can't use the spur cover. i like it there to keep crap out of moving parts.
i know your pain of being down a servo zackS30 my rs10 xt is down a rear one.

zackS30

I spent 75$ on that damn thing and its got a grand total of 7 uses on it.
I hope u figure out ur drivline issue.

phmaximus

Dead set don't worry about the gear cover, it's just a gimmick to keep little fingers out.

i could understand if it was a high preformance off-roader that kicks up a lot of dirt and rocks, then it might be some what useful?
But even then, looking at 1/8 nitro and electric stuff they don't use gear covers aswel.

i guess if u are dead set on keeping the cover u could allways just flip the skid plate around.

RustedRC

Drive line issues on what zackS30?
yeah phmaximus i did 180 it. well if the cover don't matter to much maybe i will mirror the tranny. i am going to get a 35t motor for it soon and a few more up grades here and there to have a good solid truck. maybe i can figure some thing out for a cover if it gets to that point.

zackS30

With ur shafts and tranny and such.

RustedRC

Yep there all good to go now. just axle gears and axle shafts to go and should be rock solid. well almost. i know the mods are like endless but it's getting close to where i want it.

Mike Flea

Looking forward to some pics of the completed project!

RustedRC

Soon as this long work week is up i'll post some up.