First tuber
05-03-2009, 03:19 PM
#1
Senior Member
Thread Starter
Join Date: Feb 2006
Location: Kihei ,
HI
Posts: 609
Likes: 0
Received 0 Likes
on
0 Posts
First tuber
I picked this up yesterday to good of a deal to pass up. I am waiting on a transmission and some driveshafts. I am going to make some body panels out of aluminum. I also need to figure out the ax10 trans mounting issue because this is drilled for a R2. Well i think it is pretty cool. Do you?
05-04-2009, 09:28 AM
#4
Senior Member
Join Date: Nov 2007
Location: EugeneOR
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
RE: First tuber
jessemxt If you could set up your links like this pic. I guarantee that rock rider of yours would crawler a lot better. That triangulation setup will eliminate most of your tork twist. If you could make a plastic skid plate that will make the bottom slicker.
Kevin
Kevin
