Technical difficulty
#1
Junior Member
Thread Starter
Join Date: Jul 2012
Location: London, ON, CANADA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Technical difficulty
Hi all, first post here. Anyway I have a Proboat Sanibel. I reaqlly want to love the little I had it out it seemed fast and manuverable. Anyway My secound time out the sail winch got ripped out of the hull (very flimsy) So I epoxied in two blocks of plastice to remount the servo to (still seems flimsy to me). So I'm all excited because here i'm good to go ...... Well not so fast because after I put it back together it seems The lines attached to the servo siezed somewhere in the cabin..... The only way I can figure to find out what is going on is to cut a hole in the roof of the cabin (3"'x 3"). Is this the way to go? Your experience and help would be greatly apprieciated.
David
David
#2
Senior Member
My Feedback: (1)
Join Date: Mar 2011
Location: Temecula, CA
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
RE: Technical difficulty
You don't want to cut holes in your boat unless it is absolutely necessary! I got your PM and have responded back to you. I posted a picture I found on line of the electronics bay - but it is not a very good picture. Do you have a digital camera? If so perhaps you can take a few better pictures of that areaand post them - so we can get a better look at what you have going on,
Give me a call so we can discuss your options.
Boomer
Give me a call so we can discuss your options.
Boomer