a little more on the ORCA from JAWS
02-26-2010, 02:09 PM
#1
Member
Thread Starter
Join Date: Dec 2009
Location: Pottstown,
PA
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
a little more on the ORCA from JAWS
The fighting chair is made of K & S brass. I good tip when working with this is to heat it to dull red, it then can be bent and formed easilyThe material work hardens
K&S brass tubes can be easily flattened in a vise. The flattened section can be drilled and attached with screws, I prefer tiny lag screws.
Commodore H
K&S brass tubes can be easily flattened in a vise. The flattened section can be drilled and attached with screws, I prefer tiny lag screws.
Commodore H
