Bulldog Install
#1
Senior Member
Thread Starter
Join Date: Jun 2009
Location: North Charleston,
SC
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
Bulldog Install
Hello all,
I have a Bulldog with no electronics. The wires from the turret have been cut and I have not traced them out yet. If I install a new syatem, the new HL or what ever, does the turret have to be connected to new board for tank to run the motors?
Thanks,
David
I have a Bulldog with no electronics. The wires from the turret have been cut and I have not traced them out yet. If I install a new syatem, the new HL or what ever, does the turret have to be connected to new board for tank to run the motors?
Thanks,
David
#2
If I'm reading this right, no, the turret does not have to be connected to turn the tracks. Just unplug the 8 pin connector from the board and all upper hull functions are disconnected, but all lower hull functions will still work (motors, speaker and smoke).
#3
Senior Member
Thread Starter
Join Date: Jun 2009
Location: North Charleston,
SC
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
That is what I wanted to know Crius.The turret harness has been cut for a former failed install of another system. Tracing wires.
Thanks,
David
Thanks,
David
#5
Senior Member
Thread Starter
Join Date: Jun 2009
Location: North Charleston,
SC
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the information. I ordred teh Hl 2.4 system for anothe tank to replace a old RX-13. Do I need a RX-18 to go with the HL 2.4sytem? I have some old ones that have never been installed.
Again thanks for the assistance to my questions. I searched youtube but it was not clear to me.
Thanks,
David
Again thanks for the assistance to my questions. I searched youtube but it was not clear to me.
Thanks,
David
#7