p 4 stug Henglong
#2
Senior Member
Join Date: Dec 2008
Location: Charleston, SC
Posts: 1,842
Likes: 0
Received 0 Likes
on
0 Posts
RE: p 4 stug Henglong
Whoa!!!!
Now i have never been much into assualt guns, but looking at this gem just might...I say might cause me to give the STUG another thought.
Buuba that is a fine....fine bit of work.
Don
Now i have never been much into assualt guns, but looking at this gem just might...I say might cause me to give the STUG another thought.
Buuba that is a fine....fine bit of work.
Don
#3
Senior Member
Thread Starter
Join Date: Jul 2008
Location: toronto, ON, CANADA
Posts: 803
Likes: 0
Received 0 Likes
on
0 Posts
RE: p 4 stug Henglong
thank you the gaps you see between the upper and lower hulls is because i have not screwed the hulls together yet as i have 2 more pieces left to put inside
#5
RE: p 4 stug Henglong
Excellent work! You may want to offer your R&D services to their GM.
#9
RE: p 4 stug Henglong
Looks very nice bubbajoexx! The only thing I would change are the smoke dischargers. The Stug IV had none of these.
#12
Senior Member
Join Date: Nov 2006
Location: Grande Prairie,
AB, CANADA
Posts: 8,976
Likes: 0
Received 4 Likes
on
4 Posts
RE: p 4 stug Henglong
That is a nice kit bash, and I have this on my "to do" list as well. I have a 1/18 scale RC Stug IV so I haven't been as motivated to do this conversion. Yours looks good. Not to hijack your thread but just converting a PZ IV with some flat styrene is also an option for people. THe nice thing about stugs is a lot of flat surfaces, which is easy to do in styrene.
#13
Member
Join Date: Aug 2007
Location: kailua,
HI
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
RE: p 4 stug Henglong
Very nicely done conversion. Not trying to count rivets or anything, but I was wondering if you had plans to add the driver's hatch and periscopes?