modifyit15

My Feedback: (27)

Man I took my hellfire out for an All Out SmackDown, Now Its so dirty I tried the Team Associated Cleaner and No such luck. I dont want to take it a part but if I must I will. If any of you have some Cleaning tips and helpfull products I am Listening. I am tempted to buy some Carb Cleaner I know that will do it but I dont know if it will attack my plastic parts.

PillowPants

go to home depot and get some simple green degreaser and an air compressor

wide_open247

WD 40 and a rag and a soft paint brush to get the dust off

suicidemachine

I use all of the above....simplegreen/denatured alcohol through my aircompressor( a ajustable cleaning nozzle that has a line to draw it and spray it) then WD40 and my girlfriends toothbrush(shh don't tell her)

before


after

wide_open247

Squeeky clean

pretty much anything works just don't use water on the bearings. I use some Q tips to get in all the small spots

marshon50

My Feedback: (2)

Air compressor w/ a siphon feed tube for denatured alcohol. It works best if you don't allow the mud to cake on and dry, but if it does simply use more. For economics try to blow off most of the stuff w/ just air as denatured alcohol can get costly at $12 per gallon. If you've got a compressor you don't have to be afraid of using water, just make sure to blow it dry and then spray down your entire vehicle w/ WD40 and then hit that w/ air as the final step. It takes time to get it clean but you can make it look like new w/ some effort and elbow grease.

crazytank7

Damn thats looks good i am going to try that!!!

TruggyBoy101

hey everyone does anyone know how to clean burnt on nitro fuel off a header, because its actually my friends car and it was squirting out fuel from the motor (we quickly tightened all the screws and it was fine). but it used to be silver now its all browny and horrible lol, any help is appreciated