serkan1978

Hi guys this is my first kit to build I would appreciate any comments and ideas I am planning to put saito fg 84 if it fits.

serkan1978

First I started with bottom main spar. Balsa with spruce wood lamination

serkan1978

The ribs are ready for top main spar once they are strait I will glue them

serkan1978

For the ailerons I am using MKS DS 6125 mini servo

serkan1978

Top main spar glued to the ribs I use superphatic glue

serkan1978

Wing joiner box glued to main spars now ready for the first 3 ribs

flycatch

My Feedback: (26)

I recently built an IMP TA152H 101" WS and advice you to incorporate plywood mounting plates for your landing gear.

serkan1978

I have maple wood for landing gear mount

serkan1978

The ribs are glued to wing joiner box with balsa triangles

serkan1978

The front and back spars are done

flycatch

My Feedback: (26)

The IMP kit incorporated the same type of landing gear attachment however they will tear out under a side load.

serkan1978

Thank you for the advice I will post some pictures before I install the landing gear mounts

serkan1978

The aileron mounts are glued

JGrc

My Feedback: (29)

Serkan,
good choice with the MKS servos, my Hs125 wing servos have too much play and I will be replacing them.



JoseG

JGrc

My Feedback: (29)

I've had no issues with the landing gear mount, even after a few hard landings.
Trim the maple mount to fit over W08

JG

serkan1978

The shear webbing is done I start the leading edge

JGrc

My Feedback: (29)

Serkan,

you suppose to keep the wing on the building board with the rib tabs until you sheet the top, specially when you build the leading edge otherwise you can twist the wing.
Do you still have the building guide?

JG

serkan1978

The wing still on the board after I finish the leading edge I will finish the landing gear mount.

JGrc

My Feedback: (29)

Serkan,
Awesome, make sure you don't induce any twist, which will be difficult to correct later. Place a bid of Hisol or slow epoxy around the maple mount to the ribs joints.



JG

serkan1978

Hi jose
I guess I have to install the flap servo before sheeting the wing and flap operates with one servo right?

JGrc

My Feedback: (29)

You can operate the flaps with 2 or 4 servos. I used one on each wing with a torque rod pushing the 2 flaps on each wing.

JG

serkan1978

I am planning to use one low profile hi torque servo for the flaps and I will put it between the ribs 8 and 9.

serkan1978

The first layer of the leading edge glued to sub leading edge and ribs

serkan1978

I glued the second layer of the leading edge now I have to send it

JGrc

My Feedback: (29)

Looking good, do you have a long straight edge sanding block? like a long T?

JG