Aerotech Models P-51 wing wanted
#1
Senior Member
Thread Starter
Aerotech Models P-51 wing wanted
Hello, I have been lucky enough to come across a Aerotech all carbon fibre 1/5 scale P-51 Mustang less the wing. Everything else is present but due to a shipping incident the wing was damaged and thrown away by the previous owner. I have the ability to replicate a wing but am seeing if there is something out there that may be available?????
I know it's a long shot but you never know what's sitting deep in hobby rooms around the world.
Even a partially damaged may be resurrected to a point to even take a mould of to get the end result. Thanks in advance guys.
Cheers Trent.
I know it's a long shot but you never know what's sitting deep in hobby rooms around the world.
Even a partially damaged may be resurrected to a point to even take a mould of to get the end result. Thanks in advance guys.
Cheers Trent.
#2
G'Day Trent. 22 Feb 2016. Perth W.A
Try these old threads , maybe you could get in touch with them .
Looking For Aerotech P-51 Owners
85" Aerotech P-51 Flying Input
Aerotech P-51 And Husky 2.7
Just to let you know I have under long term construction new in box ( never to part with ) one of the last
that was made for me, a long term project.
I have installed a MVVS 58 LC (liquid cooled engine with radiator ) so far , I have to make a 2.5"prop
shaft extension out of Hokotol 7050 aluminum yet.
As you know it is a carbon fibre kit , nicely done a bit weighty.
Keep in touch. I can send some photos still in raw state, to many other mustangs in the way of this build.
Regards. . EddyP51.
Keep them flying
Try these old threads , maybe you could get in touch with them .
Looking For Aerotech P-51 Owners
85" Aerotech P-51 Flying Input
Aerotech P-51 And Husky 2.7
Just to let you know I have under long term construction new in box ( never to part with ) one of the last
that was made for me, a long term project.
I have installed a MVVS 58 LC (liquid cooled engine with radiator ) so far , I have to make a 2.5"prop
shaft extension out of Hokotol 7050 aluminum yet.
As you know it is a carbon fibre kit , nicely done a bit weighty.
Keep in touch. I can send some photos still in raw state, to many other mustangs in the way of this build.
Regards. . EddyP51.
Keep them flying
Last edited by eddyP51; 02-27-2016 at 04:01 AM. Reason: Word correction