Century Jet retract w/Lado actuator
#1
Thread Starter
My Feedback: (14)
Century Jet retract w/Lado actuator
I have a set of 1/5 scale Century Jet retracts that I had Century Jet convert to electric. They worked fine for a year then one will not extend all the way. I also have another set oh Shindin retracts for a FW-190 that use Lado actuators that have never failed. Does anyone know if the Lado actuator will work on a 1/5 scale Century jet retract. I have tried to contact Lado but have not heard back from them yet.
#2
I tried to get a hold of LADO also but no luck , from what I have read if the actuator is working but the gear stalls ,
there is likely a burr on the jack screw . You can try to take them apart and run a tap over the thread to clean them up a bit.
, lube them up good and try again .. cheers Roger.
there is likely a burr on the jack screw . You can try to take them apart and run a tap over the thread to clean them up a bit.
, lube them up good and try again .. cheers Roger.
#4
Thread Starter
My Feedback: (14)
1/5 scale Century Jet retracts with Lado Actuators
I got the Lado RS666 actuators in and I have to make a mounting plates for them. The mounting plate for the Century Jet actuators just won't work. Here are a few picks of the Centruy Jet rotating retracts, I will update the next post with a picture of the Lados with the new mounting plate.
Last edited by jstanton; 02-18-2018 at 08:05 PM.