Earthquake 8E problem
#1
Junior Member
Thread Starter
Join Date: Jun 2011
Location: Spotsylvania,
VA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Earthquake 8E problem
So when i was driving my redcat earthquake 8e the wheel came off. Later i order the parts to fix it but when i put the lock nut on it stays on but when the car drives it goes down to far and locks up the wheel Ive tried lock-tight and washers but none of them worked so any suggestions ill try them
#4
Senior Member
My Feedback: (1)
Join Date: Dec 2010
Location: Quebec City,
QC, CANADA
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
RE: Earthquake 8E problem
That's sounds strange, cause the lock nut is meant to be tight. But that shouldn't stop the wheel from turning.
Have you inspected the wheel itself to see if nothing if broke?
#7
Senior Member
My Feedback: (1)
Join Date: Dec 2010
Location: Quebec City,
QC, CANADA
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
RE: Earthquake 8E problem
ORIGINAL: NewRageRC
It sounds like the pin in the back of the axle stub probably isn't seated correctly, effectively shortening the axle stub.
It sounds like the pin in the back of the axle stub probably isn't seated correctly, effectively shortening the axle stub.