default needle settings on nitro motor shockwave rc
#1
Junior Member
Thread Starter
Join Date: Dec 2011
Location: FarwellMichigan
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
default needle settings on nitro motor shockwave rc
Hi does any one know the high speed and low speeddefault needle settings. on the nitro motor in a shockwave rc
#2
RE: default needle settings on nitro motor shockwave rc
try 4 turns out on the high-speed.
3 out on the low.
2mm opening on the idle gap.
That should be good enough to get it started.
also, pre heat the motor with a hair dryer to make it easier to start if its a new motor.
3 out on the low.
2mm opening on the idle gap.
That should be good enough to get it started.
also, pre heat the motor with a hair dryer to make it easier to start if its a new motor.
#3
Join Date: Aug 2007
Location: , NY
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
RE: default needle settings on nitro motor shockwave rc
2 1/2 out on high and screw flush with collar on the low
DOUG
DOUG
ORIGINAL: deon99
Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc
Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc
#4
RE: default needle settings on nitro motor shockwave rc
ORIGINAL: codokas
2 1/2 out on high and screw flush with collar on the low
DOUG
2 1/2 out on high and screw flush with collar on the low
DOUG
ORIGINAL: deon99
Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc
Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc
#5
Join Date: Aug 2007
Location: , NY
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
RE: default needle settings on nitro motor shockwave rc
Correct you are.For breaking in ya gotta run it rich
DOUG
quote]ORIGINAL: nitrosportsandrunner
that sounds like the settings once the motor is broken in. out of the box it needs to be very rich for breaking in the motor.
[/quote]
DOUG
quote]ORIGINAL: nitrosportsandrunner
ORIGINAL: codokas
2 1/2 out on high and screw flush with collar on the low
DOUG
2 1/2 out on high and screw flush with collar on the low
DOUG
ORIGINAL: deon99
Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc
Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc
[/quote]