What size of screw or part number do I need?
#1
Member
Thread Starter
Join Date: Nov 2011
Location: Mt. Pleasant, MI
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
What size of screw or part number do I need?
I lost a screw that goes from the front lower control arm into the steering knuckle on my Shredder. I purchased every screw I could basically find for the shredder and none of them are it.
I was going to take the one out of the other front and even with blue lock-tite on it, it stripped out. So I can see the actual size of the screw. Any help is appreciated.
I was going to take the one out of the other front and even with blue lock-tite on it, it stripped out. So I can see the actual size of the screw. Any help is appreciated.
#2
RE: What size of screw or part number do I need?
ORIGINAL: ShredderGuy
I lost a screw that goes from the front lower control arm into the steering knuckle on my Shredder. I purchased every screw I could basically find for the shredder and none of them are it.
I was going to take the one out of the other front and even with blue lock-tite on it, it stripped out. So I can see the actual size of the screw. Any help is appreciated.
I lost a screw that goes from the front lower control arm into the steering knuckle on my Shredder. I purchased every screw I could basically find for the shredder and none of them are it.
I was going to take the one out of the other front and even with blue lock-tite on it, it stripped out. So I can see the actual size of the screw. Any help is appreciated.
#3
Member
Thread Starter
Join Date: Nov 2011
Location: Mt. Pleasant, MI
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
RE: What size of screw or part number do I need?
Yeah, I looked at the schematic and that screw is not listed as a part numer. I will have to call Redcat tomorrow I guess.
#4
RE: What size of screw or part number do I need?
ORIGINAL: ShredderGuy
Yeah, I looked at the schematic and that screw is not listed as a part numer. I will have to call Redcat tomorrow I guess.
Yeah, I looked at the schematic and that screw is not listed as a part numer. I will have to call Redcat tomorrow I guess.
#6
Junior Member
Join Date: Dec 2011
Location: Beaumont, TX
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
RE: What size of screw or part number do I need?
If im correct you are talking about "ball head covers"...do they look like nuts but with threads on outside and a hex in the middle that goes all the way through?
I have a tornado s30 but maybe you can use this for a reference...
(The schematic i found for your shredder was poor in quality and i couldnt make out any part numbers)
So heres the Schematic for the part on my tornado i think youre talking about (look at part # 02153) -http://www.redcatracing.com/c.849850...e/tornado.html
And a link to a picture of the actual part..
Hope this helps...
FrostY