Bushing in servo save Earthquake 8e
#1
Junior Member
Thread Starter
Join Date: Oct 2011
Location: Amsterdam, NETHERLANDS
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Bushing in servo save Earthquake 8e
Hey all, I have an Earthquake 8e and am trying to find the size of the bronze bushings in the bellcrank and the servo safer so I can replace them with bearings, but the information does not seem to be available anywhere on the internet. Any help would be greatly appreciated.
#3
Junior Member
Thread Starter
Join Date: Oct 2011
Location: Amsterdam, NETHERLANDS
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bushing in servo save Earthquake 8e
It seems as though no one knows. I may have to measure them and make an educated guess in the end. I'll let you know if I get something that works
#4
Junior Member
Thread Starter
Join Date: Oct 2011
Location: Amsterdam, NETHERLANDS
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bushing in servo save Earthquake 8e
I took some measurements and am fairly sure the bearings should measure 8 millimeters wide, the hole is 7 millimeters wide and the whole thing is 2 millimeters high.
I also tried a reely alu servo saver, but it did not fit at all! Does anyone know of a servo saver which would fit this thing?the slop in the steering is really substantial and the servo saver seems vulnerable too.
I also tried a reely alu servo saver, but it did not fit at all! Does anyone know of a servo saver which would fit this thing?the slop in the steering is really substantial and the servo saver seems vulnerable too.