help with volcano epx pro
#1
Junior Member
Thread Starter
Join Date: Jan 2013
Location: Fairland, IN
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
help with volcano epx pro
I just got the volcano epx pro. Charged the battery (8 hours) programmed the esc and toke it out. When I hit the gas full throttle it cuts in and out. I think that it's the battery or the escbut don't really know any help would be great. Thanks to all
#2
RE: help with volcano epx pro
ORIGINAL: [email protected]
I just got the volcano epx pro. Charged the battery (8 hours) programmed the esc and toke it out. When I hit the gas full throttle it cuts in and out. I think that it's the battery or the esc but don't really know any help would be great. Thanks to all
I just got the volcano epx pro. Charged the battery (8 hours) programmed the esc and toke it out. When I hit the gas full throttle it cuts in and out. I think that it's the battery or the esc but don't really know any help would be great. Thanks to all
just posted an answer on your other thread.
could be a defective battery. do you have another model to test it with? or another charger to charge it with?
#5
Junior Member
Thread Starter
Join Date: Jan 2013
Location: Fairland, IN
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
RE: help with volcano epx pro
yes it is brushless. I'm using NIMH battery now because that's what came with it. Only had it for about two days. My first electronic I have always had gas.
#6
Senior Member
Join Date: Dec 2010
Location: Sebring,
FL
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
RE: help with volcano epx pro
II asked about the being brushless and having a nimh battery because I had a similiar issue last year with an rc. I got an Exceed RCRally Monster, the brushless edition, which also shipped with an included nimh battery. I charged it once the truck was unboxed. I then took it for a test run and it did the same. I later found out that the truck (esc) was pre-programmed for lipo mode)
Hope this helps, perhaps nitrosportsandrunner can help you with programming the esc if thats the case.
Hope this helps, perhaps nitrosportsandrunner can help you with programming the esc if thats the case.