caldera 10e question
#1
Junior Member
Thread Starter
Join Date: Oct 2013
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
caldera 10e question
ok first off hi everyone im new here. i have a caldera 10e that i just got a week ago, i ran a fully charged 2s in it one time an now it wont move i have steering but thats it, the book says esc may have overheated an resetting it may solve the problem, problem is i dont know how to reset it and there isnt anything in the book on how to do it. any help would be greatly appreciated.
#2
ok first off hi everyone im new here. i have a caldera 10e that i just got a week ago, i ran a fully charged 2s in it one time an now it wont move i have steering but thats it, the book says esc may have overheated an resetting it may solve the problem, problem is i dont know how to reset it and there isnt anything in the book on how to do it. any help would be greatly appreciated.
Are you sure it didn't just go into Low Voltage Mode? LVC protects your from over draining the lipo battery. It will cut power to the motor but give you steering. It will not work again until the lipo is charged or a different battery is used.
How long did it run before this happened?
If you want to try re-calibrating the ESC, the process is shown here:
http://www.youtube.com/watch?v=_OkwkziFWE8