final install of project $300 shockwave
#1
Senior Member
Thread Starter
Join Date: Jan 2007
Location: Cinnaminson,
NJ
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
final install of project $300 shockwave
the last of the aluminum parts for it. Not it officially has ALL of the aluminum parts available from Redcat on it..
#6
Senior Member
Join Date: Nov 2007
Location: Bridgewater,
NJ
Posts: 3,961
Likes: 0
Received 0 Likes
on
0 Posts
RE: final install of project $300 shockwave
Now it's time for the radio system, servos, and engine
It really does look great! I'm planning to (eventually) do this to my Volcano.
It really does look great! I'm planning to (eventually) do this to my Volcano.
#8
Senior Member
Thread Starter
Join Date: Jan 2007
Location: Cinnaminson,
NJ
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
RE: final install of project $300 shockwave
thanks guys.. I will take it in the dirt.. I have changed one servo so far with a Futaba and the rado is my vintage Airtronics XL2P radio. Works reall nice. I have a 6v ni mh battery for the transmitter too and now the servos are VERY fast. BTW the car has bearings throughout too and the diffs are smooth as silk. I can grab and spin a wheel and they actually spin for a few seconds.. not instantly stop. Its very loose.. The engine is HPI Nitro star 15 and its wayyyy faster then the original VTX 16..
http://www.rcuniverse.com/forum/m_66..._1/key_/tm.htm
http://www.rcuniverse.com/forum/m_66..._1/key_/tm.htm
#13
Senior Member
Thread Starter
Join Date: Jan 2007
Location: Cinnaminson,
NJ
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
RE: final install of project $300 shockwave
Eddie.. I never weighted it before but now its 4.6 lbs without fuel. For comparison my Sons 1/8th nitro car is 8.4 lbs without fuel. Can someone weight a stock Shockwave for comparison??
I sure does not FEEL any heavier then it was stock
*update** I just checked on a GS SB1 1/10th 4wd truggy and its weight stock is 5.1 lbs for comparison,. Mostly plastic parts
I sure does not FEEL any heavier then it was stock
*update** I just checked on a GS SB1 1/10th 4wd truggy and its weight stock is 5.1 lbs for comparison,. Mostly plastic parts
ORIGINAL: ehroof
is it alot heavier than stock?
is it alot heavier than stock?