Redcat Racing Support Moderated Support Forum for all Redcat Racing Cars, Trucks & Buggies

3.5/Ultralite line owners, clutch bell fitting help, aftermarket bell

Reply
Old 02-11-2014, 05:52 PM
  #1
JDMS206
Thread Starter
 
Join Date: Feb 2014
Posts: 2
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Question 3.5/Ultralite line owners, clutch bell fitting help, aftermarket bell

friend was nice enough to CNC a nice set of wheels for me. They're a little smaller than the stock wheels that came on my backdraft so now the stock gearing setup is well spent in no time at all so I need a little more top end now. I know the stock bell is an 18t, uses 5*10*4 bearings and is mod1. Well id really appreciate if anyone could tell me if I could run a 20t savage bell? If so, would I just have to swap the bearings from my redcat bell over to the savage bell, slap it back on and remesh? I do have enough room to run the bigger bell I'm pretty sure. 20t will give me exactly what I need. I think all I would need is just the savage bell and everything should fit. I Can't thank you guys enough! Oh, the bell I want to use is HPI #77110. If you guys know another 20t bell that'll work too, post it for me!

Last edited by JDMS206; 02-11-2014 at 05:59 PM.
JDMS206 is offline  
Reply With Quote
Reply


Thread Tools
Search this Thread
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -8. The time now is 04:58 AM.