Redcat vehicle repair/tune FAQ
#1228
Junior Member
Join Date: Mar 2017
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
ok cant figure out my lsn i do pinch test get it in sweet spot...but needle is only turned out 1/4 turn from closed. I have put both hsn and lsn back to factory and just dumps oil out of it.
#1230
Junior Member
Join Date: Apr 2017
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Good day. I am trying to install a 2 speed clutch bell for the 2 speed transmission. This will be our 2nd one. On the first one we just switched the bearings and put all back together and it works fine. On the 2nd one after installing the bearings and bolting back down the clutch will not turn. I made sure all the correct washers were in place. I took it back apart and tried again. The clutch will not turn. If I put old 1 speed back on it works fine. spins freely like it should. Any ideas on what I am doing wrong? Or did I just get a bad part?