Drill Start
#2
RE: Drill Start
the hpi nitrostar .15 will fit, its an exact fit, with the starter wand, it should run around $40
http://www2.towerhobbies.com/cgi-bin...?&I=LXFET0&P=7
http://www2.towerhobbies.com/cgi-bin...?&I=LXFET0&P=7
#3
Senior Member
Join Date: Dec 2006
Location: greenville, SC
Posts: 434
Likes: 0
Received 0 Likes
on
0 Posts
RE: Drill Start
if u have a good drill, this is all you need.
http://www2.towerhobbies.com/cgi-bin...?&I=LXFET1&P=7
but think about it cause its kinda bulky, and you have to carry the drill and stuff around. i like that if my cars cut off all i need is the glow iginter, 1 or 2 yanks and im ready to go again. $0.02
http://www2.towerhobbies.com/cgi-bin...?&I=LXFET1&P=7
but think about it cause its kinda bulky, and you have to carry the drill and stuff around. i like that if my cars cut off all i need is the glow iginter, 1 or 2 yanks and im ready to go again. $0.02